Webasto Thermo & Comfort SE
Postfach 1410
82199 Gilching
Germany
Internet: www.webasto.com
Technical Extranet:
http://dealers.webasto.com
Ident. No.: 1324052C_EN Status: 06.10.2016 © Webasto Thermo & Comfort SE
60
Audi A1
Final Work
Reassemble the components in reverse order. Check all hoses, clamps and all electrical connec-
tions for firm seating. Insulate and tie back loose lines.
Only use manufacturer-approved coolant. Spray the heater components with anti-corrosion wax
(Tectyl 100K).
• Connect the battery.
• Fill and bleed the coolant circuit according to the vehicle manufacturer’s specifications.
• Program MultiControl CAR, teach Telestart transmitter.
• Make settings on the A/C control panel according to the ‘Operating Instructions’.
• Place the ‘Switch off parking heater before refuelling’ caution label near the filler neck.
• For initial startup and function check, please see installation instructions.
Ensure sufficient distance from neighbour-
ing components, correct if necessary.
Aligning ex-
haust pipe
a2
Install rubber isolator 3, route air filter box
drain pipe
2 as shown and attach using
cable tie
1.
Installing
drain pipe of
air filter box
To Next Page
Loading...
