WEEDO M2 - Page 46

43
Daily Repair and Maintenance
Skip step 2 and step 3, adjust the gap between prinng plaorm and nozzle
according to the step 4, step 5, step 6 and step 7 in turn.
Adjust two nuts at the back of plaorm boom part in synchronizaon; adjust
the gap between plaorms and nozzle, unl A4 paper has slight friconal
resistance in sliding. Aer well adjusted, press buon “OK” to enter next step.
Homing axis X/Y
Adjust front one thumb
nuts until nozzles touch,
press OK
Adjust back two thumb
nuts until nozzles touch,
press OK