Wega EVDS io - 6.8 Water Replacement; Initial Water Replacement Procedure; Water Renewal After Short Inactivity; Pre-dispensing Cycles for Priming

38
User manual
6.9.4 Raised cup grilles
When using cups with dierent heights, the special
ippable grilles that are supplied with the machine can
be used.
To use the grille, unhook it from the latch and rotate
it downwards into a horizontal position.
When it is no longer
needed, push it upwards,
until it latches into place.
To clean the grilles,
see paragraph “8.5.1 Gen-
eral instructions” page
42.
6.9.5 Cup warmer
Place the cups to be heated on the cup heater (17).
For safety reasons, we do not recommend placing cloths or other
objects on the cup warmer shelf in order to prevent the machine
from overheating.
6.10 Dispensing coee
• Place the coee cup under the
dispensing spout
• press the desired dose button,
for example
STOP
PROG.
and wait
for the coee to nish being
dispensed;
• To stop the coee dispensing
ahead of time, press either the
STOP
PROG.
button ;
When using small-sized cups, a specic raised cup grille (14) is
available.
To programme the dispensing procedure, see chapter “7.1 Coee
doses” page 39.
Do not remove the lter holder from the dispensing group when
coee is being dispensed.
Do not insert your ngers or any other objects into the lter holder.
17
STOP
PROG.
14