Wega WBAR EVD User Manual

TECHNICIANS' manual
- English -
26 di 52
Every electrical connection operation must be carried
out with the mains o and the power supply discon-
nected. The Technician must also check that there is
no voltage present, by using a multimeter, for example.
The electrical system must be equipped with a protec-
tion device (46) that ensures an omnipolar disconnec-
tion from the mains with a contact opening distance
in overvoltage category III conditions and which guarantees a
suitable residual-current device, equal to 30 mA, in compliance
with current laws and safety regulations.
Always connect the motor pump cable before the ma-
chine power supply cable, by following the diagram
provided. Failure to comply with the instructions giv-
en above may cause serious damage to the machine and/or mo-
tor pump and will invalidate any guarantee.
We recommend that you promptly report any problems encoun-
tered during the appliance’s installation to the Manufacturer.
6. COMMISSIONING
6.1 Safety precautions
Carefully read the instructions provided in chapter "I.
SAFETY PRECAUTIONS" on page 3.
6.2 Preparing the filter holders
6.2.1 Filter holders
• Place the filter-holding spring (B) in the housing of the fil-
ter holder (A).
• Take the (C) or (D) one-cup filter and press it firmly into the
filter holder.
6.2.2 Beccucci
Completare il portafiltro con il montaggio del beccuccio per
una tazza (E) o due tazze (F).
A
F
D
E
B
C
Properly connect the single filter with the single spout
and the double filter with the double spout.
6.2.3 Grinding and dosing coee
It is important to have a grind-
er-dispenser next to the ma-
chine so that the coee can be
ground on a daily basis.
To adjust the coarseness of
the ground coee, use the ap-
propriate regulator located on
the grinder-dispenser hopper.
The coee must be ground
and dispensed according to instructions provided by the man-
ufacturer of the grinder-dispenser. The following points should
also be kept in mind:
• To obtain a good espresso it is not recommended that you
store large amounts of coee beans. Comply with the ex-
piry date indicated by the producer.
• Never grind large volumes of coee, it is advisable to pre-
pare the amount that can be held in the dosing device and
if possible, use it by the end of the day.
• Do not buy pre-ground coee, as it perishes quickly. If nec-
essary, buy coee in small vacuum-sealed packs.
To adjust the coarseness of the ground coee, use the
appropriate regulator located on the grinder-dispens-
er hopper.
6.3 Cup warmer (if fitted)
For safety reasons, we do not recommend placing
cloths or other objects on the cup warmer shelf in or-
der to prevent the machine from overheating.
HIGH TEMPERATURE HAZARD: the cup warmer can
reach temperatures that may cause burns. Be very
careful.
Place the cups to be heated on the cup heater (7). Turn ON the
switch
of the service button panel (6).
7
6
It is recommended to turn o the device when not
needed.
Pay attention to the position of the
switch when using the device (see
diagram).
Cup Warmer
OFF
Cup Warmer
ON

Wega WBAR EVD Specifications

General

Brand	Wega
Model	WBAR EVD
Category	Coffee Maker
Language	English