TECHNICIANS' manual
- English -
5 di 52
care with the following:
• When indoors, always provide air vents.
• Check for any gas leaks.
• Do not under any circumstances attempt
to light the gas without first installing the
proper injector.
• Do not start up the gas burners when the
heating unit is empty.
Only perform the maintenance and cleaning
operations indicated in this manual.
If the problem cannot be resolved, switch o
the machine and contact the Manufacturer.
All maintenance operations must be carried
out when the power supply has been turned
o, the water mains has been closed o, and
the machine has completely cooled down.
After maintenance and/or repair work, the
components that are used must ensure that
the hygiene and safety requirements initially
provided for the appliance are still met. These
are met by only using original spare parts.
When components which come into contact
with water or food are repaired or replaced, a
washing procedure has to be carried out, as if it
were the first installation.
The Technician must inform the User
about the methods of periodic testing
of pressure equipment and safety devices in
accordance with the legislation in force in the
country of installation.
I.VI. EMERGENCY SITUATIONS
Should an emergency situation occur as a result
of a machine malfunction, adopt the measures
provided for in the emergency plan posted in
the premises and in any case, proceed to im-
mediately carry out the actions based on the
type of problem.
SHORT CIRCUIT FIRE
In the event of a fire caused by the machine’s
electrical system malfunctioning, adopt the
following behaviours:
• Disconnect the machine from the power
mains via the main switch.
• Call the fire and rescue service.
• Get everyone a safe distance away from the
premises.
• Extinguish the flames using a CO2 fire ex-
tinguisher.
GAS LEAK
In the event of a fire caused by the machine’s
system malfunctioning, adopt the following
behaviours:
• Shut o the gas supply by closing the valve
upstream of the machine.
• Get everyone a safe distance away from the
premises.
• Ventilate the premises.
• Call the technician that installed the ma-
chine.
• If necessary, call the fire and rescue service.
GAS LEAK FIRE
In the event of a fire caused by the machine’s
gas system malfunctioning, adopt the follow-
ing behaviours:
• Shut o the gas supply by closing the valve
upstream of the machine.
• Disconnect the machine from the power
mains via the main switch.
• Call the fire and rescue service.
• Get everyone a safe distance away from the
premises.
• Extinguish the flames using a CO2 fire ex-
tinguisher.