WeighTech WT3000-P - Page 16

WEIGHTECH USA Weighing indicator WT3000-IR ABS– Technical manual
Wt3000irabs v20151126
16
aplied, the indicator shows the resulto on the display with the
caption "HOLD".
After activate the animal weighing function, the user must set the
parameters for weighing calculation as the table below shows.
Code
Description
003.000
Weight variation
range to initiate new
weight calculation
0-Máx Capacity
hoLd 6
Tare operation for hospital care
This function allows the user top ut or remove weight from the
scale without change the NET weight value.
Top ut or remove any weight in the scale without change the
NET weight value press , put or remove any load from the
scale and then press again.
After activate this function the user must set a weight variation
range to activate the bed abandonment alarm.
Code
Description
003.000
weight variation
range to activate the
bed abandonment
alarm.
0% - 100%. máxima
FnC-07
Average
weight
AvErG0
Average weight on
AvErG0
AvErG1
Average weight off
FnC-08
Unused
parameter.
---.---
Unused parameter.
---.---
FnC-09
Unused
parameter.
---.---
Unused parameter.
---.---
FnC-10
Inicial zero
memory
Z oFF
Zero memory off
Z oFF
Z on
Zero memory on
Important: This function is not available if the parameter CFn 02 = 4
FnC-11
Foot switch
function
ZEro
The foot switch acts like the “Zero” key.
ZEro
tArE
The foot switch acts like the “Tare” key.
Print
Performs the accumulation of the weight value show on the
display and sends the information through the serial port.
FnC-12
F key function
mC
Erase the records of accumulations performed.
hr
hr
For 5 seconds the weight is displayed with one more decimal place.
t-tP
Enters the pre-tare function
t-b
Activates the alarm for bed abandonment function (FnC 06 – hold 6).
r-HOLD
Starts a new weight calculation during live animal weighing function.