上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
34 / 53
You can also do the following for a program file in the host or a USB flash disk:
• F2: edit the target program file.
• F3: delete the target program file.
• F5: unload the loaded program file.
• F6: create a program file.
• F7: rename the target program file.
• F8: copy the target program file into NK300CX.
3.1.2 Load a Program File from the Internet
This operation is used to establish network connection between NK300CX and PC,
to realize two-way transmission between them.
To load a program file form the internet, fo the following:
1. Set the IP address.
2. Verify the connection.
3. Access a shared program file.
3.1.2.1 Set the IP Address
This operation is used to establish the network connection channel between
NK300CX and PC by automatically obtaining or manually setting the IP address.
It is default to automatically obtain the IP address. And this operation takes
manually setting the IP address as an example.
Before setting the IP address, ensure that NK300CX and PC are in the same subnet.
To set the IP address, do the following:
1. Press → 2 → F1. Network Setting dialog box pops up:
To Next Page
Loading...
