Operation 27
• The 12 Volt vehicle power supply using the
WM 10650 connection cable;
• The FW7405M/14 mains/charger unit, complete
WM 2610.
A red adapter ring is fitted to the vehicle connec-
tor. This is needed if you want to insert the vehi-
cle connector in a cigarette lighter socket. To
connect to the mains / charger unit FW7405M/
14, complete WM 2610 or a 12-volt vehicle
socket, you must remove the red adapter ring.
Caution: Check the vehicle plug for correct
polarity. Reversed polarity can damage
ACCUVAC Basic.
Charging without wall bracket
1. Switch off ACCUVAC Basic.
2. Place the plug at the appliance end of the con-
necting cable in the guide slot at the rear of the
appliance and push it up behind the cover plate.
3. Switch on the power supply.
4. Charging starts as soon as you have switched on
the power supply. When the top LED lights up,
the power pack is approx. 75 % charged. Please
charge the battery for another two 2 hours at
least.
5. Disconnect the connecting cable once the device
has charged.
To Next Page
Loading...
Need help?
General
