28 Operation
Charging using the WM 10750 charger plug
The WM 10750 charger plug has an LED on the
front panel that shows the current status of the
device:
– Orange: charging
– Green: refresher charging
Because of the way the WM 10750 charges, the
charge LEDs on the ACCUVAC Basic show the status
“full” very quickly, even though the battery will not
be fully charged yet. You are therefore advised to re-
fer to the charge LEDs on the charger plug.
The enclosed primary adapters can be used if you are
using the WM 10750 charger plug with different
mains connections in other countries.
To change the primary adapter, gently push the
adapter fitted to the charger plug away from the
charger in the direction indicated by the arrow. In-
sert the required adapter into the free mounting and
push firmly into place.
Charging with wall bracket
1. Switch off ACCUVAC Basic.
2. Insert ACCUVAC Basic in the wall bracket.
To Next Page
Loading...
Need help?
General
