Tools and test equipment 39
8. Tools and test equipment
Below is a list of all tools and test equipment used in these service and repair instructions.
The particular tools and test equipment required are outlined in each respective chapter.
Special tools can be purchased from the manufacturer Weinmann.
8.1 General tools
• Slotted screwdriver size 0.5 x 3 x 100
• Crosstip screwdriver, size 1
• Crosstip screwdriver, size 2
• Open-ended spanner SW 7
for tube connection on pressure gauge
• Open-ended spanner SW 14
for vacuum connection 10
• Open-ended spanner SW 16
for cap WM 22204 on oxygen outlet 7
• Open-ended spanner SW 17
for toggle switch
• Open-ended spanner SW 19
for connection coupling AGA
• Open-ended spanner SW 22
for special tool G 3/8
• Tweezers
for sieve set
• Bulldog end cutting nippers
for single-lug clips
• Pliers.
8.2 Special tools
The following tools are available from the manufacturers Weinmann:
• Special tool set, consisting of: WM 15348
– Special spanner SW 14.2 WM 22396
– Special socket wrench with cross-bar WM 22392
(for pressure regulator WM 15138)
– Special spanner SW 20 with handle bar WM 22391
– Special tool G 3/8 WM 22827
(for unlocking the AGA coupling
and the oxygen inlet 5
and inhalation 11 connections)
– Special tool WM 22397
(for holding the knob 9 steady)
– Guide pipes, for toggle switch. WM 22398
• Set, supply test Medumat / Modules WM 15440
• Set, supply test Modules WM 15441
• Set, test set respiration and pressure reducer flow WM 15443
To Next Page
Loading...
