High Torque Rotary Unit • ST0055 - ST0140 • R04-2014
29/42
Commissioning
6.2 Initial commissioning
6
6.2 Initial commissioning
If the machine is delivered with servo drive and software, the start-up is conducted via
the Weiss Application software WAS.handling Windows programme.
More information is also contained in the operating manual WAS.indexer Control
ST0055 - ST0140 .
6.3 Recommissioning
Risk of injury emanating from an operationally unsafe machine.
An operationally unsafe machine can cause injuries and material damage. Recommis-
sioning should only be realised after it has been ascertained that the machine is in a
functionally reliable condition and no risk emanates from it during operation.
A visual inspection of the machine should be conducted prior to re-commissioning. The
following should be checked and ensured in this regard:
• No damage is present on the machine.
• No foreign materials, tools or other objects are lying in the operating area of the
machine.
• All supply units are connected and operating.
• Safety equipment is ready for operation.
To Next Page
Loading...
