Technical Manual
SureTemp
®
Model 670/SureTemp 4
®
Model 675 37
INSTALL INSULATION TAPE ALONG METAL SURFACE OF TRANSFORMER AS SHOWN.
1
CLEAN CONTACT AREA ON LCD AND PCA WITH ISOPROPYL ALCOHOL. THEN ALLOW
TO DRY BEFORE ASSEMBLY.
2
FINGER PROTECTION MUST BE WORN DURING ASSEMBLY OF ELASTOMERIC
CONNECTOR.
3
INSPECT ELASTOMERIC CONNECTOR FOR VISIBLE CONTAMINATION: IF
CONTAMINATED, DO NOT USE OR ATTEMPT TO CLEAN.
4
NOTES: UNLESS OTHERWISE SPECIFIED
2
1
TRANFORMER
DIATEK P/N
52005-000
MAIN PCA
MODEL 670: DIATEK P/N 20905-000
MODEL 675: DIATEK P/N 20905-010
34
2
FRAME
DIATEK P/N 25092-000
LCD
DIATEK P/N 60011-000
ZEBRA CONNECTOR
DIATEK P/N 58112-000
LAMP
DIATEK P/N 58104-000
DISPLAY PCA
DIATEK P/N 20926-000
BOTTOM VIEW
FIGURE 7 - ELECTRONICS ASSEMBLY
To Next Page
Loading...
