SAFETY INSTRUCTIONS
AVOIDING THE RISK OF SKIN
BURNS
• Before entering a spa, the user should
measure the water temperature since the
tolerance of water temperature-regulating
devices varies.
• To reduce the risk of injury, before
entering a spa the user should measure
the water temperature with an accurate
thermometer.
• Test the water with your hand before
entering the spa to be sure it’s comfortable.
PRODUCT SAFETY AND MAINTE-
NANCE
For units intended for use in other than
single-family dwellings, a clearly labeled
emergency switch must be provided as
part of the installation. The switch must
be readily accessible to the occupants and
must be installed at least 5 feet (1.52 m)
away, adjacent to, and within sight of, the
unit.
When the spa is not in use, cover the spa
with the cover to prevent ultraviolet radia-
tion causing damage to the product.
Do not remove any suction sealing. Do
not operate the spa if the suction sealing is
broken or missing.
Keep your clothes and jewellery away
from rotating jets and moving parts.
Test the residual current device before use.
Disconnect the spa from the power supply
before servicing its electrical parts. (This
operation can only be performed by quali-
fied professionals).
It is strictly prohibited to use the spa in a
not completely assembled state (e.g. de-
tached side panel)
Chemical treatment of water can only be
performed by per- sons under the age of 18
under parental supervision.
Maintenance can only be performed by
trained professionals.
The user should check the electrical wiring
every 3 months. It is required to perform a
check by a professional every 3 years.
Mains fuses / circuit breakers may be acti-
vated because of power outages.
Installation and wiring of the spa, replace-
ment of power cord, and any repairs must
be performed by qualified profession- als.
It is required to build in an isolating device
to the fixed wiring.
PLUG’N’PLAY SAFETY WARN-
INGS BEYOND THE PREVIOUS
WARNINGS, PLEASE ALSO PAY
ATTENTION TO THE UNDER-
MENTIONED ONES.
ATTENTION! The electrical receptacle
must be located at least 2.5 meters from
the spa so that bathers in a sitting position
cannot reach it from the water. The plug
can only be connected to a receptacle
equipped with 2.5mm 2 diameter cables.
ATTENTION! RISK OF ELECTRIC
SHOCK. The connector with residual
current device must be inspected before
every use.
ATTENTION! Only place the RCD plug in
a receptacle equipped with RCD.
ATTENTION! Before you insert the plug
into the socket ensure that the current of
the socket and the fixed wiring is appro-
priate for the properties of the spa.
The spa must be equipped with an isolation
transformer or powered through a residual
current device with a release current not
exceeding 30mA.
This product is equipped with a ground
fault circuit breaker (GFCI) in the
connector. GFCI must be tested before
each use.
If the power cable is damaged, it must
immediately be re- placed by the manufac-
turer or a service professional in order to
minimize danger.
10
To Next Page
Loading...
