Wellis MARBELLA - Purges

MODIFYING WATER CARE SCHEDULES
You can modify the programmed
schedules by selecting one and adjust-
ing the schedule.
You have several possibilities for the
schedule (Mon-Fri, weekend, every day,
or single days). The schedules will be
repeated every week. The time and du-
ration are set in 30 minute increments.
PURGES
Touch the Purge tab to change the
purge settings. You can add purges by
touching the « + » symbol.
To delete a schedule, touch the gar-
bage can icon at the right end of the
desired line.
Once you have set the schedule, use
the calendar icon to go back.
You can modify the programmed
purges by selecting one and adjusting
the schedule.
You have several possibilities for the
schedule (Mon-Fri, weekend, every day,
or single days). The schedules will be
repeated every week. The time and du-
ration are set in 30 minute increments.
Once you have set the purge,
use the calendar icon to go back.
In Economy mode, the set point will be
reduced by 20°F, which means that the
heating system will not be engaged
unless the temperature falls to 20°F below
the spa's set temperature.
The filtration schedule shown on the
screen will apply to the main filtration
pump, most likely pump 1. If your spa uses
a circulation pump configured to run 24
hours, the screen will show you the purge
setting instead of filtration. The purges
are pre-programmed for a fixed number
of minutes, therefore the duration will
be set to N/A on the screen, and only the
start time can be modified.
USER INTERFACE  SMART TOUCH
30