Wellis MARBELLA - In.clear (in Smart Touch)

OPTIONAL ACCESSORIES  IN.CLEAR IN SMART TOUCH
IN.CLEAR OPERATING MODES
IF YOU ARE A USING A SMART TOUCH, PLEASE REFER TO THE USER INTERFACE SECTION TO GET THE IN-
STRUCTIONS ABOUT THE SANITIZATION MODE.
MAINTENANCE MODE
Maintenance Mode keeps the bromine bank levels at a stable
and acceptable range when the spa is not being used. Main-
tenance mode is the “everyday” mode and is automatically
ON when the system is activated. Maintenance level adjust-
ment changes the rate at which bromine will be released into
the spa water.
Finding and setting the right maintenance level will keep
the residual bromine level between 3 and 5 PPM (the
recommended range) when the spa is not being used or is
left unused for an extended period of time. Once the proper
maintenance level is determined, keep the same setting un-
less the spa conditions change (change in water temperature,
spa location, etc).
Finding the right bromine generation level is a crucial step
for the in.clear system to be stable and effective (see Set
Maintenance Mode).
It is important to note that the in.clear system can ONLY
generate bromine when the water is circulating. If you are
having problems maintaining a stable level of bromine, or
determining the proper maintenance level for your spa, you
may have to increase the daily filtering time. Longer filtration
produces a more steady level of bromine.
BOOST MODE
The Boost Mode should be activated every time you use
your spa. Boost mode increases the bromine generation
rate to attack pollutants in the water and helps rebuild the
necessary residual bromine in the water after each use of the
spa. Pollutants are introduced to the water by the bathers,
causing the bromine levels to decrease. Activating the boost
mode when you enter the spa will prevent inadequate
bromine levels and will restore your bromine to the proper
residual level.
Finding the right boost level is another crucial step for the
in.clear system to be stable and effective.
If water quality is not good after use, only the boost
level should be adjusted, not the maintenance level.
direct to function
selection wheel:
– on/off
– bromicharge
– boost level
– maintenance
statuts and messages
mode selection
wheel:
in.clear icon
56