MAINTENANCE MODE
Maintenance Mode keeps the bromine bank levels at a stable
and acceptable range when the spa is not being used. Main-
tenance mode is the “everyday” mode and is automatically
ON when the system is activated. Maintenance level adjust-
ment changes the rate at which bromine will be released into
the spa water.
Finding and setting the right maintenance level will keep
the residual bromine level between 3 and 5 PPM (the
recommended range)when the spa is not being used or is
left unused for an extended period of time. Once the proper
maintenance level is determined, keep the same setting un-
less the spa conditions change (change in water temperature,
spa location etc).
Finding the right bromine generation level is a crucial step
for the in.clear system to be stable and effective (see Set
Maintenance Mode).
With the stand alone version, the spa filtration should
be set to a minimum of 8 hours per day. To check the
minimum filtration time for your spa, see the Program
Key section.
With the linked version, it is not necessary to set the
filtration duration, as communication between the
pack and in.clear allows the system to stop and start the
associated pump at the best times.
It is important to note that the in.clear system can ONLY
generate bromine when the water is circulating. If you are
having problems maintaining a stable level of bromine, or
determining the proper maintenance level for your spa, you
may have to increase the daily filtering time. Longer filtration
produces a more steady level of bromine.
BOOST MODE
The Boost Mode should be activated every time you use your
spa. Boost mode increases the bromine generation rate to
attack pollutants in the water and helps rebuild the necessary
residual bromine in the water after each use of the spa. Pol-
lutants are introduced to the water by the bathers, causing
the bromine levels to decrease. Activating the boost mode
when you enter the spa will prevent inadequate bromine lev-
els and will restore your bromine to the proper residual level.
Finding the right boost level is another crucial step for the
in.clear system to be stable and effective.
If water quality is not good after use, only the boost
level should be adjusted, not the maintenance level.
On/Off &
Boost key
Maintenance
Diagnostic key
Down key
Up key
Bromine Generation
Indicator
lo
hi
BromiCharge gauge
IN.CLEAR OPERATING MODES
This manual details the functions of the in.clear with the default keypad (in.k200). If your spa pack uses a compatible keypad
(ex. in.k800) please see its manual for more specific information.
KEYPAD FUNCTIONS
OPTIONAL ACCESSORIES IN.CLEAR
51
To Next Page
Loading...
