EasyManua.ls Logo

Wellis MARBELLA - Page 8

Wellis MARBELLA
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY INSTRUCTIONS
IMPORTANT: Failure to wait 30 seconds
before resetting the GFCI may cause the
spas Power Indicator (on the control panel)
to blink. If this occurs, repeat the GFCI
test procedure.
DANGER - RISK
OF ELECTRIC SHOCK
A wire connector is provided on this unit
to connect a minimum 8 AWG
(8.4 mm
2
) solid copper conductor be-
tween this unit and any metal equipment,
metal enclosures of electrical equipment,
metal water pipe, or conduit within 5 feet
(1.5 m) of the unit.
• Install at least 5 feet (1.5 m) from all
metal surfaces. As an alternative, a spa
may be installed within 5 feet of metal
surfaces if each metal surface is perma-
nently connected by a minimum 8 AWG
(8.4 mm
2
) solid copper conductor to the
wire connector on the terminal box that
is provided for this purpose.
Do not permit any electric appliance,
such as a light, telephone, radio, or
television, within 5 feet (1.5 m) of a spa.
Failure to maintain a safe distance may
result in death, or serious personal injury
due to electrocution, if the appliance
should fall into the spa.
• Install your spa in such a way that drain-
age is away from the electrical compart-
ment and from all electrical components.
• CAUTION — Risk of Electric Shock.
Do not leave compartment door open
• CAUTION — Risk of Electric Shock.
Replace components only with identical
components
• Do not service this product yourself as
opening or removing covers may expose
you to dangerous voltage or other risk
of injury. Refer all servicing to qualified
service personnel.
DO:
• Be sure your spa is connected to the
power supply correctly - use a licensed
electrical contractor.
• Disconnect the spa from the power sup-
ply before draining the spa or servicing
the electrical components.
• Test the Ground Fault Circuit Interrupt-
er(s) before each use.
• Do not use the spa with the equipment
compartment door removed.
• Do not place electrical appliances within
5 feet (1.5m) of the spa.
• Do not use an extension cord to connect
the spa to its power source. The cord
may not be properly grounded and
the connection is a shock hazard. An
extension cord may cause a voltage drop,
which will cause overheating of the jet
pump motor and motor damage.
• Do not attempt to open the electrical
control box. There are no user service-
able parts inside.
RISKS TO AVOID
DANGER - RISK OF INJURY
To reduce the risk of injury to persons,
DO NOT remove suction fittings (filter
standpipes) located in the filter compart-
ment.
There is a danger of slipping and falling.
Remember that wet surfaces can be very
slippery. Take care when entering or
exiting the spa.
Never operate spa if the suction fittings
are broken or missing.
People with infectious diseases should
not use the spa.
Keep any loose articles of clothing, long
hair, or hanging jewelry away from ro-
tating jets or other moving components.
8

Table of Contents

Related product manuals