Log in here with the credentials of your router (default user is adm and default password is 123456). If you have
logged in successfully, you will see the following screen.
From here on you can use the following commands for help, analysis, configuration, etc.
Another way to connect to the router via the CLI is via a serial console cable. This is plugged into the console port
of the router and connected to the PC.
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 140
To Next Page
Loading...
