3.13.1 3.12.1. Help Command
Help can be retrieved aer entering help or “?” into the console, “?” can be entered at any time during command
entry to get the current command or help from the command parameters, and the command or parameters can be
auto‑completed if only the command or command parameter is present.
Entering help at the command prompt gives a short description of how to use the help command. If you append
the “?” to a command, the possibilities that you can use in connection with the command are displayed. If there is
no output, no or no further command exists for this input.
3.13.2 3.12.2. Show Command
The show command can be used to display parameters of the router or the configuration of the router. The help
command or the “?” indicate the commands that can be used in combination with show.
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 141
To Next Page
Loading...
