Parameter
Description
Factory
settings
Initial Com‑
mands
Start commands e.g. if Triggered by SMS is selected or special AT commands
are to be used.
blank
RSSI Poll Inter‑
val
Polling interval of the signal strength 120 sec‑
onds
Dial Timeout Maximum time for the dial‑up attempt 120 sec‑
onds
MTU Maximum size of a package 1500 bytes
Netmask An additional netmask can be entered here blank
Infinitely Dial
Retry
If Triggered by SMS is selected, the dialing can be set to infinite here o
Dual SIM En‑
able
Enable/disable the dual SIM option. If this option is activated, special selection
fields are available (see below)
disabled
Main SIM The main sim card that will be used SIM1
Max Number
of Dial
Maximum connection attempts, then restart of the modem 5
Min Con‑
nected Time
Minimum connection time 0 seconds
CSQThreshold Minimum signal strength SIM1 / SIM2 0
CSQ Detect In‑
terval
Interval for signal strength query SIM1 / SIM2 0 seconds
CSQDetectRe‑
tries
Repeat attempts for signal strength query SIM1 / SIM2 0
Backup SIM
Timeout
Time aer which it is switched back to the main SIM card 0 Sekun‑
den
Debug If enabled, more detailed logging is done disabled
If a provider is unavailable, the system switches to the alternative provider. The same applies when the mobile data
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 50
To Next Page
Loading...
