volume is used up. The TK 800 uses ICMP to monitor the data connection. If this is no longer available (because the
ping fails), the router switches to the other connection.
3.2.2 3.2.2. Ethernet
In the Ethernet area, you have the option to make settings for the network ports. Depending on the model, you can
adjust the interfaces individually. It is important to know that the router models have a network interface with the
designation FE 0/1 and a network bridge, which is designated FE 1/1 to 1/4 depending on the model.
3.2.2.1. Ethernet Status
The status page shows the current status of the network ports (depending on the model).
3.2.2.2. Fast Ethernet 0/1
Here you can adjust the settings of the network interface with the label FE 0/1.
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 51
To Next Page
Loading...
