PPPoE List
Parameter
Description
Enable Enables or disables the PPPoE entry
ID Assign any unique ID
Pool ID The pool ID previously created via Dial Pool for the interface via which the connection is to
be established.
Authentication
Type
Auto, PAP, CHAP can be selected. In most cases this parameter can be set to Auto.
Username The username you received from your provider for dial‑up.
Password The password you received from your provider for dial‑up.
Local IP Address Your local IP address
Remote IP Ad‑
dress
IP address of the remote device (modem)
Keepalive Inter‑
val
Time aer which the connection should be checked.
Keepalive Retry Number of attempts when a connection check fails.
Debug Detailed logging is performed when activated.
The wizard can also be used to set up a PPPoE connection via New WAN. This is easier than the manual configura‑
tion!
3.2.5 3.2.5. WLAN (TK8x5‑EXW)
3.2.5.1. WLAN Status
Under Network > WLAN you can first view the status of the WLAN.
For example, the current SSID of the router, the IP address or the role of the WLAN module (access point or client)
can be read here.
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 57
To Next Page
Loading...
