The TK800 series routers do not have a built‑in ADSL modem. For the use of ADSL dialup, an external ADSL modem
must be connected to the WAN port. For the digital transmission technology, an appropriate DSL modem that
supports the new IP technologies is required.
3.2.4.2. ADSL Dialup (PPPoE)
Here you can configure the dial‑in via the DSL modem for PPPoE. The TK800 does not have its own DSL modem, so
these cannot dial in independently.
In this case, an appropriate DSL modem that can handle the new IP technologies is required. The modem should
meet the following criteria:
• VDSL2/ADSL2 Ethernet‑Modem
• Annex A/B/M/J compatible
• PPPoE bridge operation
• IPv4 and IPv6 compatible
• DSL standards
– ANSI T1.413 Issue 2
– ITU G.992.1 A/B (G.dmt)
– ITU G.992.2 (G.lite)
– ITU G.992.3 (VDSL2)
– ITU G.992.4 (G.HS)
– ITU G.992.5 (ADSL2+)
You should therefore ensure that the modem is connected to the router before you start the configuration. The DSL
modem should be connected to the FE 0/1 interface or to a defined VLAN port.
Dial Pool
The Pool ID is used to define the Interface for the PPPoE dial up.
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 56
To Next Page
Loading...
