Whirlpool CS2320 - Convection Mode Operation; Forced Air Mode Operation

■
Convection Mode
■
Forced Air Mode
The upper and lower heaters and rear fan operate simultaneously in this mode. Suitable for all baking dishes, such as meat,
seafood, pizzas, bread and cookies, pastries and desserts. It is recommended to place aluminum foil or baking paper onto
the baking tray before cooking.
Temperature Time
Default Setting 180℃ 30 mins
Setting Range 100℃ - 230℃ 5 mins - 3 hours and 59 mins
Example: Set the cooking time to 40 minutes; cooking temperature is 210°C.
Steps:
1. In standby mode, turn the knob clockwise to
Convection Mode. The icon will ash. Press the knob to conrm
(as shown in the diagram below). The display will jump to hour setting automatically.
2. Press the knob to conrm the 00 hour setting (as shown in the diagram below). The display will jump to minute setting
automatically.
3. Turn the knob until the minute display shows 40. Press the knob to conrm (as shown in the diagram below). The display
will jump to temperature setting automatically.
4. Turn the knob until the temperature display shows 210°C. Press the knob to conrm (as shown in the diagram below).
5. Setting is complete. The combi steamer will start cooking.
The appliance comes with a rear fan which distributes the hot air produced by the rear heater evenly inside the oven. Foods
on dierent levels are heated evenly. It can be used in cooking multiple levels. It is recommended to place aluminum foil or
baking paper onto the baking tray before cooking.
Temperature Time
Default Setting 180℃ 30 mins
Setting Range 100℃ - 230℃ 5 mins - 3 hours and 59 mins
Example: Set the cooking time to 40 minutes; cooking temperature is 210°C.
Steps:
1. In standby mode, turn the knob clockwise to
Forced Air Mode. The icon will ash. Press the knob to conrm (as shown
in the diagram below). The display will jump to hour setting automatically.
2. Press the knob to conrm the 00 hour setting (as shown in the diagram below). The display will jump to minute setting
automatically.
3. Turn the knob until the minute display shows 40. Press the knob to conrm (as shown in the diagram below). The display
will jump to temperature setting automatically.
4. Turn the knob until the temperature display shows 210°C. Press the knob to conrm (as shown in the diagram below).
5. Setting is complete. The combi steamer will start cooking.
64 65
Operation Instructions
Operation Instructions
S48893-Whirlpool Combi Steamer User Manual_EN_V12.indd 64-65 26/7/2016 下午12:55