WIKA UniTrans UT-10 User Manual

C
Universal Pressure Transmitter UniTrans
Installation
Published 16.2.04
Subject to change due to technical modifications. © Copyright WIKA Alexander Wiegand GmbH & Co. KG / BRD
WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg ·

(09372) 132 - 710 · Fax - 706 · E-mail: support-tronic@wika.de · www.wika.de
55
•
All functions are pro
g
rammable once the pressure transmitter has been up
g
raded
with a displa
y
unit. The adjusted parameters are stored after the displa
y
unit is re-
moved.
The displa
y
unit can be rotated in 300°, so that it can be read under various installation
conditions. The housin
g
cover with built-in displa
y
can be fastened to the housin
g
at
all four side positions.
4.3 Housing Reconfiguration
Rotate the housin
g
of the displa
y
unit in order to be able to read the displa
y
from
above when the pressure transmitter is installed in an upri
g
ht position.
• Loosen the 4 internal hexa
g
onal screws.
• Li
g
htl
y
lift off the housin
g
with the displa
y
unit.
• Carefull
y
turn the housin
g
b
y
180°.
• Re-ti
g
hten the screws.
When tightening the 4 hollow screws, make sure that they are ade-
quately and securely seated in order to ensure that the transmitter is
properly sealed.
Connection Cable
Supporting String
Attention

WIKA UniTrans UT-10 Specifications

General

Brand	WIKA
Model	UniTrans UT-10
Category	Transmitter
Language	English