WIKA UniTrans UT-10 User Manual

Published 16.2.04
C
Universal Pressure Transmitter UniTrans
Installation
Subject to change due to technical modifications. © Copyright WIKA Alexander Wiegand GmbH & Co. KG / BRD
WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg ·

(09372) 132 - 710 · Fax - 706 · E-mail: support-tronic@wika.de · www.wika.de
56
4.4 Electrical Connection
The suppl
y
volta
g
e is between 12 and 36 V DC. The power suppl
y
and the output si
g
-
nal are transmitted via a two-wire cable (max. 12 mm outer diameter, max. 14 AWG)
and connected in accordance with the pin confi
g
uration.
Suppl
y
volta
g
e can be supplied b
y
a power unit, a transmitter power suppl
y
or b
y
means of a PLC connection.
It is su
gg
ested to use a model with inte
g
rated li
g
htnin
g
protection for preventin
g
dam-
a
g
e due to volta
g
e peaks.
Please observe local installation regulations (Germany: VDE-Standard).
The terminal voltage should not exceed 36 V.
Attention

WIKA UniTrans UT-10 Specifications

General

Brand	WIKA
Model	UniTrans UT-10
Category	Transmitter
Language	English