WIKA UniTrans UT-10 User Manual

Published 16.2.04
C
Universal Pressure Transmitter UniTrans
Diagnostics and Service
Subject to change due to technical modifications. © Copyright WIKA Alexander Wiegand GmbH & Co. KG / BRD
WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg ·

(09372) 132 - 710 · Fax - 706 · E-mail: support-tronic@wika.de · www.wika.de
74
7 Diagnostics and Service
The followin
g
error messa
g
es can appear on devices with displa
y
s
(see chapter 2.1.3):
8 Disposal
If a failure cannot be repaired, the transmitter must be switched off.The op-
erator then must make sure, that it is only switched on again after the
failure has been repaired.
Repairs should only be carried out by the manufacturer. All other repairs or
modifications are unauthorized.
Error Code Error Error Correction Measures
E00 ROM-error Return device to manufacturer
E01 Power suppl
y
error Check power suppl
y
E03
E
2
PROM communications error
Disconnect and reconnect power
suppl
y
E04 Sensor’s temperature ran
g
e was
exceeded
Return sensor’s temperature to
specified limits
E06 Sensor reco
g
nition Disconnect and reconnect power
suppl
y
E07 General communications error
between the sensor and the con-
trol interface unit
Check the connection between
the sensor and the control inter-
face unit
E08
Error E
2
PROM
send in transmitter for service
Please observe local guidlines and regulations when disposing of trans-
mitters that are no longer serviceable.
Please turn any recycleable components in to the appropriate local orga-
nizations.
Attention
Important

WIKA UniTrans UT-10 Specifications

General

Brand	WIKA
Model	UniTrans UT-10
Category	Transmitter
Language	English