WIKA UniTrans UT-10 User Manual

C
Universal Pressure Transmitter UniTrans
Operation of Transmitters with Display
Published 16.2.04
Subject to change due to technical modifications. © Copyright WIKA Alexander Wiegand GmbH & Co. KG / BRD
WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg ·

(09372) 132 - 710 · Fax - 706 · E-mail: support-tronic@wika.de · www.wika.de
65
6.4 Default Data (factory settings)
Function Defaults
Displa
y
Unit of measurement
(Line 1)
Line 2
Line 3
Pressure displa
y
(in bar)
Temperature displa
y
(in °C)
Sensor’s nominal pressure ran
g
e (in bar)
Calibration zero 4 mA
span 20 mA
nom. pressure ran
g
e start
nom. pressure ran
g
e end
Output Dampin
g
Inversion
Fault
Limits
I-offset
0 s
no
21 mA (upscale)
3.8 ... 20.5 mA
0 mA
Service password no active password
Service mountin
g
correction not activated
Lan
g
ua
g
eEn
g
lish
Evaluation linear
densit
y
y
es
1
g
/cm
3
Calibrated special measurement ranges i. e. 4 bar on a 6 bar transmit-
ter can be adjusted by factory pre-setting. A reset to default will reset
the sensor back to its nominal range (i. e. 6 bar). The factory pre-setting
gets lost.
Important

WIKA UniTrans UT-10 Specifications

General

Brand	WIKA
Model	UniTrans UT-10
Category	Transmitter
Language	English