Wilo EHV G2 - DN 50/2RK - Page 36

INSTALLATION English
Installation and operating instructions Wilo EHV G2 - DN250 35
5.2.2. Fastening with HAS... / HIS anchor bolts
• These anchors may only be used in reinforced or unreinforced normal concrete with
astrengthclassofbetweenC20/25andC50/60(accordingtoEN206:2000-12).
• The anchor bolts are only suitable for crack-free concrete. Optionally, anchor bolts are
also available for cracked concrete.
• The foundation for the anchors should be dry.
• Before using the anchor bolts, the strength of the structure must be ascertained in order
to ensure that the reaction forces can be absorbed.
• Take care not to damage the grout cartridge during transport, as otherwise the adhesive
cement will harden.
• Do not use defective or old grout cartridges (see the use-by date).
• Groutcartridgesmayonlybestoredbetween+5°Cand+25°C.Theymustbestored
inacool,dryanddarkplace.
• Hazard labeling on grout cartridges
CAUTION – irritant substances!
The grout cartridges contain dibenzoyl peroxide. This substance is an irritant!

• R36/38 – causes eye and skin irritation
• R43 – may cause sensitization by skin contact
• S37/39 – wear suitable protective clothing when working
• S26 – in case of contact with eyes, rinse thoroughly with water and seek
medical advice
• S28 – after contact with skin, wash immediately with water and plenty


Type
Rod
length
Drill hole
depth
Drill hole
diameter
Minimum
distance
to edge
Minimum
foundation
thickness
Tightening
torque
Maximum
component
thickness
HAS-R M8x80/14 110 mm 80 mm 10 mm 100 mm 130 mm 10 Nm 14 mm
HAS-R M12x110/28 160 mm 110 mm 14 mm 135 mm 160 mm 40 Nm 28 mm
HAS-R M16x125/38 190 mm 125 mm 18 mm 155 mm 175 mm 80 Nm 38 mm
HAS-R M16x125/108 260 mm 125 mm 18 mm 155 mm 175 mm 80 Nm 108 mm
HAS-E-R M20x170/48 240 mm 170 mm 24 mm 210 mm 220 mm 150 Nm 48 mm*
HAS-E-R M24x210/54 290 mm 210 mm 28 mm 260 mm 260 mm 200 Nm 54 mm*
HIS-RN M16x170 170 mm 170 mm 28 mm 210 mm 220 mm 80 Nm **
W-FA 10/15/85 85 mm 70 mm 10 mm 65 mm 100 mm 30 Nm 10 mm
*Withoutexternalhexhead
** M16 female thread