Winterhalter P50 - 18 Decommissioning for a Period of Disuse; 19 Recommissioning after a Period of Disuse20; 20 Technical Data

Decommissioning for a period of disuse
20
18 Decommissioning for a period of disuse
If the machine needs to be out of operation for a long duration (holidays, seasonal business), proceed as
follows:
 Empty the machine using the self-cleaning programme ( 9.1.2).
 Clean the machine ( 9.1.3 and 9.1.4).
 Leave the hood open.
 Close the on-site water stop cock.
 Switch off the local mains disconnector.
 Store detergent and rinse aid containers frost-free.
If the machine is in a place that is not frost-free:
 Instruct an authorised service technician to make the machine frost-resistant.
 The engineer must drain the boiler, pump, solenoid valve and any chemical dosing system attached to
the machine.
19 Recommissioning after a period of disuse
After extended periods of disuse, proceed as follows:
 Open the on-site water stop cock.
 Reinstall detergent and rinse aid containers.
 Switch on the local mains disconnector.
 Switch on the machine.
If the machine was in a place that was not frost-free:
After extended periods of disuse, the machine must be completely climatised (at least 24 hours at 25 °C). If
this requirement is met:
 Contact an authorised service technician to put the machine back into service.
20 Technical data
Voltage
see rating plate
Total connected load
Fuse
Minimum flow pressure
 15.1
Maximum inlet pressure
Water inlet temperature
Dimensions