3 Safety notes
3.1 General safety notes
Read through the safety notes and operating instructions in this manual carefully. Re-
tain the operating instructions for future reference. Winterhalter Gastronom GmbH does
not assume liability or warranty in case of non-adherence to these safety and operating
instructions.
Use the dishwasher only after you have read and understood the operating instructions.
Allow the Winterhalter Customer Service Department to provide information about the
operation and functioning of the dishwasher.
Train the operating personnel as regards handling the machine and inform them about
the safety notes. Repeat the training sessions at regular intervals to prevent accidents.
Operate this machine only when it is in perfect condition.
A damaged or leaking machine may endanger your safety. In case of defects, switch off
the machine immediately. Do not switch the machine on until the defect has been recti-
fied. Switch off the local mains disconnector (main switch). Only then is the machine
without power.
Do not open any machine covers or machine parts if it requires tools. There is danger of
shock.
Contact your installer or electrician if the on-site water or electricity supply is the cause
of the malfunction.
Contact an authorised service technician or your retailer if any other fault has occurred.
Do not make changes, additions or reconstructions in the dishwasher without the ap-
proval of the manufacturer.
For your safety, test the on-site residual current circuit breaker (FI) regularly by pressing
the test button.
Close the on-site water stop cock after the work is complete.
Switch off the on-site mains disconnector after the work is complete.
3.2 Electrical Safety
The electrical safety of this machine is guaranteed only if it is connected to a correctly
installed protective circuit and a residual current circuit breaker. It is crucial that this
basic safety requirement is tested and, in case of doubt, that the house installation is
checked by a qualified electrician.
Winterhalter cannot be held responsible for damage caused by a missing or broken pro-
tective conductor (e.g. electrical shock).
3.3 Maintenance and repair work
Maintenance work and repairs may only be performed by authorised Winterhalter ser-
vice technicians. Improper maintenance or repairs may cause significant danger for the
user, for which Winterhalter is not liable.
When performing maintenance and repair work, unplug the machine from the power
network. Electricity consumers (heating element) are under voltage until the local mains
disconnector has been operated.
Only original Winterhalter spare parts may be used for maintenance and repairs. If orig-
inal spare parts are not used, the warranty is invalidated.
If the mains cable of this machine is damaged, it must be replaced by the Winterhalter
or its Customer Service or another qualified person in order to prevent hazards. The
mains cable must be an H07 RN-F type or equivalent.
To Next Page
Loading...
