6.1 Rinse aid
A rinse aid is necessary to ensure that water on the dishes drains off after washing and dries off after a short
while. Rinse aids are automatically supplied from a storage container outside the machine into the boiler of
the machine. The rinse aid dosing device is either an in-built or external component of the machine. The
authorised service technician sets the dosing amount when commissioning the machine.
INFO The rinse aid dosing device is not included in the scope of delivery of all machines. When using an
external dosing device, a transfer strip is available for connecting the dosing device ( 17).
6.2 Detergent
Do not use acidic detergents.
Do not mix different detergents in order to prevent efflorescence which could destroy the
detergent dosing device ( 6.3).
Do not use products that can create foam, e.g. hand soap, soft soap, hand wash liquid. En-
sure that these do not enter the machine even during the pre-treatment of the dishes.
A detergent is necessary to ensure that the leftovers and dirt on the dishes is cleaned. Detergents can be
supplied as follows:
Manually as detergent powder.
Automatically from an external container using a built-in or an external detergent dosing device.
INFO The detergent dosing device is not included in the scope of delivery of all machines. When using
an external dosing device, a transfer strip is available for connecting the dosing device ( 17).
6.2.1 Manual dosing of detergent powder
Pre-dosing
Switch on the machine and wait until the display is lit green.
Adhere to the dosing instructions on the packaging of the detergent. The machine's tank capacity is ap-
prox. 28 litres.
Place approx. 90 g of detergent powder in the machine. This corresponds to a dosing of approx. 3 g/l.
Then start the wash cycle immediately to mix the detergent powder with the water.
Post-dosing
At each wash cycle fresh water enters the dishwasher. This water must be mixed with detergent powder as
follows:
Fresh water
per wash cycle
Required detergent powder
after 5 wash cycles
6.2.2 Automatic dosing of liquid detergent
The authorised service technician sets the dosing amount when commissioning the machine.
6.3 Changing the detergent product
Mixing different detergents can lead to efflorescence that can lead to a failure of the deter-
gent dosing device. This is applicable even if the new detergent is from the same manufac-
turer.
The dosing hoses and the detergent dosing device must be thoroughly rinsed with water
before the new detergent is used.
A new detergent product usually requires a new setting of the detergent dosing device. Contact an au-
thorised service technician to set the dosing amount.
If this is not done, the warranty and product liability of Winterhalter Gastronom GmbH expires.
To Next Page
Loading...
