s
h
a
d
o
w
8
shadow 8
s
h
a
d
o
w
8
1/2”
Strain
Relief
Conn.
1/2”
Straight
Conn.
1/2”
Threaded
Coupling
1/2”
Liquid-
tight
Size #1
Standoff
Clip for
attaching
to press
Shadow 8
Pigtail and
Conn.
Shadow 8
Main or Ext
Cable
= Mounting surface
Mating Quick
Disconnects
Main
RX/TX
RX/TX
Main
Cables
1
2
3
4 5
Ext.
RX/TX
Ext.
RX/TX
End cap
shadow 8
1/2” Liquidtight
connector
BRAKE WARNING
INTERRUPTED STROKE
TOP STOP ANGLE
AUTO CARRYUP
STOP TIME LIMIT
MICRO-INCH
STOPPING TIME
STOPPING ANGLE
90
°
STOP TE ST
COUNTER
COUNTER PRESET
ANGLE / SPM
cam on angle
cam off angle
WPC 2000
Wintriss
®
Clutch/Brake Control
WPC SETTI NGSRESET/SELECT MUTE
STROKE SELECT MO DE SELEC T MICRO-INCH
WPC 2000
Gland
Connector
shadow 8
Run
Prog
6
Example: 1 Main, 3 Extensions, and cables using ½” Liquidtight conduit & fittings for connection to optional control or WPC
1 T&B (Thomas and Betts or equivalent) Strain relief straight connector
2 T&B (Thomas and Betts or equivalent) Size #1 Standoff Clip
3 T&B (Thomas and Betts or equivalent) ½ inch straight connector
4 T&B (Thomas and Betts or equivalent) ½ inch threaded coupling
5 T&B (Thomas and Betts or equivalent) ½ inch Liquidtight flexible metal conduit
6 T&B (Thomas and Betts or equivalent) ½ inch Liquidtight connector
Notes: 1.) All connectors and Liquid-tight must be ½” for Shadow 8 connector to pass through the connector.
2.) Remove blue heat formed insulator from T&B straight connector (if present) to allow quick disconnect to pass through it.
3.) Slice strain relief connector bushing with sharp razor knife so it will slip over cable. Do not use plastic retaining ring.
4.) You may use a junction box instead of the standoff clip (item 2) to attach the Liquidtight conduit to the mounting surface.
Figure A. Installing Shadow 8 Cabling in Liquidtight Conduit
To Next Page