Chapter 4: Web Management
EN-76
4.4.2 Button Console
This option allows you to configure the Wireless Button Console settings.
1. Click .
2. Select the location, device number, and specify the sensor name.
Click on the pull-down menu to see more options.
3. In the Remote Control field, select one automation-type device to
enable remote automatic control.
4. To bind multiple links with the automation-type controllers while pushing
the Panic button, select the controller ID in the Switch link field and click
Add. Select ON or OFF the device when the alarm is triggered.
5. In the Switch link field, click Remove to delete the current binded
automation-type device.
6. Click Apply to save the settings.
• You may press the respective button (FA/PA/DA) to change the alarm mode.
• While in emergency, press and hold FA button to trigger the emergency alert.
• When using this device with an automation-type device, press and hold PA
button for 3 seconds to turn on the device connection. Press and hold DA button
for 3 seconds to turn off the device connection.
Full Arm mode
Partial Arm mode
Disarm mode
To Next Page
Loading...