Wittenstein LUC+125 - Installation; Preparations; Installation and Initial Operation

Lubricator Operating manual
Revision: 02
2022-D064493
en-10
5 Installation
• Before commencing work, read the general safety instructions (see section
2.7 “General safety instructions”).
5.1 Preparations
NOTE
Compressed air can damage the seals of the lubricator.
• Do not use compressed air to clean the lubricator.
5.2 Installation and initial operation
The lubricator is delivered vented with a screwed-on
cartridge and mounting bracket mounted.
Optional:
• Unscrew the cap of the cartridge.
• Screw the cartridge onto the lubricator.
• Mount the lubricator in the desired position
(see section „3.4 Technical data“ for the mounting
specifications).
Mount the supplied tube connector.
Max. tightening torque: 2 Nm.