Wittenstein LUC+125 - Expert Menu Programming

Lubricator Operating manual
Revision: 02
2022-D064493
en-20
6.8 Changing parameters in the Expert menu
NOTE
Changes made in the Expert menu can fundamentally affect the function of the lubricator.
Change the parameters in the Expert menu only if you are aware of the effects..
The following parameters can be set in the Expert menu:
• Pulse mode Pu
• Emptying time t
• Number of cycles C
• Pressure P
• Cartridge size U
• Inversion of the output signals E
• Empty signal L
• Feedback / Motor running check F
A description of the individual parameters can be found in section “6.1 Adjustable parameters”.
NOTE
The emptying time t can only be set on the lubricator when it is not controlled by an external
controller (Pu0).