Wolf BMK - Standard settings

16
3062878_201707
9. Operating level 1
9.2 Operating data
Pressing Prg leads to the operating data, where pressing displays the following
set and actual system values in sequence.
Overview:
→ Extractair/setroomtemperature
→ Settemp.setvaluetransducer
→ Roomtemperature
→ Extractairtemp
→ Settemp,vent.air
→ Vent.airtemperature
→ Setvaluehumidity(room/extractair)
→ Setvaluehumidity(ventilationair)
→ Rel.humidity(room)
→ Rel.hum.,extractair
→ Rel.hum.,vent.air
→ Pressure
→ Flowrate
→ Proportionfreshair
Main menus
Standard settings
Display
Time functions
Contractor
DISPLAYSELECTIONEsc BACK
9.3 Main menu
By pressing
EscEsc
you reach the main menu. There, by pressing you select from
the menu points displayed in the overview. After selecting the required menu point,
you enter the required sub-menu by pressing
. Pressing
EscEsc
returns you to the
standard display. If no adjustment is made for more than 2 minutes, the standard
display will return automatically.
Overview:
→ Standard settings
→ Display
→ Timefunctions
→ Heatingcontractor
9.3.1 Standard settings
Standard mask
Esc
Main menu Standard settings
The most fundamental functions of the air handling system, such as 7-day program,
backup mode, night ventilation and natural cooling can be enabled or disabled
here. Furthermore, the set temperature and the fan speed as well as the fresh air
proportion for manual mode are determined in the standard settings.
Pressing enables you to select the following standard settings in sequence.
GE-01
DISPLAYSELECTIONEsc BACK
STANDARD SETTING
Set temp value for
manual mode
21.0°C
Set temp value for
manual mode
Pressing highlights the temperature that can then be changed with in steps
of0.5°C.Finallyconrmtheselectedvaluewith .
Please note
The selected set temperature only applies in manual mode.
GE-02
DISPLAYSELECTIONEsc BACK
STANDARD SETTING
< OFF >
Fan, manual mode
Fan stage / fan enable
for manual mode
Pressing changes the fan stage for stepped fans; for variable speed fans the fan
will be enabled or disabled.
Please note
The selected value only applies in manual mode.