Wolf BMK - 4 Appliance Description

9
3062878_201707
- Removing, bypassing or disabling of safety and monitoring equipment is
not permissible.
- The system must only be operated if it is in perfect technical condition.
Ensurethatanyfaultsordamagethatmayimpactonsafetyarerectied
immediately.
f Intended use
The Wolf KLM air handling and ventilation module is designed exclusively for
use in conjunction with Wolf appliances and Wolf accessories.
The Wolf KLM air handling and ventilation module is designed for the control
of air handling and ventilation systems.
It is normally matched to the system at the factory.
The BMK air handling programming module is designed for display and
operation of the KLM-XL air handling and ventilation module. The BMK is
available for mounting into the front of control panel doors (part no. 2744742)
and for wall mounting (part no. 2744743). Up to 2 programming modules can
be connected to one control unit.
The BMK- F remote control unit (part no. 2744751) is designed to start/
stop the system and to correct the fan speed, temperature and the fresh air
proportion. Furthermore, utilisation time extension and peak ventilation may
be activated. System faults are displayed on the remote control unit.
f Improper use
Any use other than the intended use is not permissible. Any other use or
changestotheproductatanytimeincludingduringttingandinstallation
invalidate all warranty claims. The user has sole liability for such use.
This appliance is not designed to be used by persons (including children)
withlimitedphysical,sensoryormentalcapabilitiesorwithinsufcient
experience and/or knowledge, unless they are supervised by someone
responsible for their safety or instructed by that person in the use of the
appliance.
4. Appliance description