Operation Multi 197i
48
ba75339e04 07/2009
4.7.3 Outputting the data storage
You can output the contents of the data storage:
z Stored data on the display
z Calibration data on the display
z Stored data on the serial interface
z Calibration protocol on the interface
Outputting stored data
on the display
You can perform the following activities:
1 Press the <RCL> key repeatedly until StO dISP appears on the
display.
2 Press the <RUN/ENTER> key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
Display further data of the data record
(ID number, date, time, storage location)
Press <RUN/ENTER>
Toggle between two saved measured vari-
ables
Press <RUN/EN-
TER> + <M>
Advance one data record (storage location) Press <▲>
Go back one data record (storage location) Press <▼>
To Next Page
Loading...
