wtw pH 3310 - Manual Storage

pH 3310 Operation
51
ba75802e02 12/2008
4.5.1 Manual storage
You can transmit a measurement dataset to the data storage as
follows: The dataset is at the same time output to the interface:
If the storage is full The following window appears if all 200 storage locations are occupied:
You have the following options:
z To erase the entire storage, confirm Yes.
z To cancel the storage process and switch to the measured value
display, confirm No. Then you can e.g. transmit the stored data to a
PC (see section 4.5.3) and subsequently erase the storage (see
section 4.5.4).
1 Press the <STO> key shortly.
The menu for manual storage appears.
2 If necessary, change and confirm the ID number (1 ... 10000)
with <▲><▼> and <ENTER>.
The dataset is stored. The instrument switches to the
measured value display.
Data record: 4 From 200
30.10.2008 11:24:16
pH 7.000 24.8 °C AR +++
ID number: 1
Continue
Manual data storage
22.09.2008
08:00
Back
Data storage full. Erase?
Yes
No
Warning
22.09.2008
08:00
Back