wtw pH 3310 - Transmitting data (USB interface)

pH 3310 Operation
57
ba75802e02 12/2008
4.6 Transmitting data (USB interface)
4.6.1 Options for data transmission
Via the USB interface you can transmit data to a PC. The following
table shows which data are transmitted to the interface in which way:
Note
The following rule applies: With the exception of the menus, shortly
pressing the <F2>/ [USB output] key generally outputs the display
contents to the interface (displayed measured values, measurement
datasets, calibration records).
Data Control Operation / description
Current
measured values
of all connected
sensors
Manual z With <F2>/[USB output].
z Simultaneously with every
manual storage process
(see section 4.5.1).
Automatic, at
intervals
z With <F2
_>/[USB output]
.
Then you can set the
transmission interval.
z Simultaneously with every
automatic storage process
(see section 4.5.2).
Stored measured
values
Manual z Displayed dataset with
<F2
_>/[USB output] after
calling up from the storage.
z All datasets with the
Output to USB function.
For details, see section 4.5.3.
Calibration records Manual z Calibration record with
<F2
_>/[USB output].
For details, see section 4.6.
Automatic z At the end of a calibration
procedure.