wtw pH 3310 - Editing the Measured Value Storage

pH 3310 Operation
55
ba75802e02 12/2008
4.5.3 Editing the measured value storage
The contents of the manual or automatic measurement data storage
can be shown on the display and output to the interface.
Each of the measurement data memories has a function to erase the
entire contents.
Editing the data storage The storage is edited in the menu, Storage & config/ Data storage. To
open the Storage & config menu, press the <F1
_>/[Menu] key in the
measured value display.
Note
The settings are explained here using the manual storage as an
example. The same settings and functions are available for the
automatic storage.
Settings
Menu item Setting/
function
Description
Data storage /
Manual data storage /
Display
- Displays all measurement
datasets page by page.
Further options:
z Scroll through the
datasets with <▲><▼>.
z Output the displayed
dataset to the interface
with <F2>/[USB output].
z Quit the display with
<F1>/[Back].
Data storage /
Manual data storage /
Erase
- Erases the entire manual
measurement data
storage.
Note:
All calibration data remains
stored when this action is
performed.