BackGround Music (BGM), level 3
PRINCESS – Edition: 17.02.2005
31
OPERATING INSTRUCTIONS
If the Playstimulator does not work:
Check if:
! the clock is set correctly ?
! start and stop time is programmed?
! repeat time is set correctly (not 0)?
! BGM play mode is disabled (ref. to next chapter).
! credits are still in memory.
Exit the serviceprogram:
1. Set the slide switch ‘service’ at the SCC unit to OFF.
2. Press ‘LT’ button.
The changer starts an initialisation run. After this the jukebox is ready to operate.
9.4 BackGround Music (BGM), level 3
If BGM is programmed and activated a random
track from the CDs declared for BGM will be
played. The time between the last selected
played track and the first BGM track is program-
mable between 1 and 98 minutes. This time is
also the repeat time between two BGM tracks.
The volume for BGM reproduction is reduced
compared to the normal volume. It is adjustable
with the two BGM pots (RH channel / LH chan-
nel) on the amplifier. BGM mode is active when
the LED on the amplifiers lights. The source of
the BGM control signal is the SCC unit plug
brown (X6), pin 1. Once the BGM mode is acti-
vated, it is not possible to operate the Playsti-
mulator.
If a selection is made by means of coin insertion
the track being played will be interrupted imme-
diately. Two intervals can be programmed for
each weekday.
To enable BGM (level 3):
1. Set the slide switch ‘service’ on the SCC-unit to ON.
2. Press ‘LT’ button.
3. Press selection button R -hold down- and press selection button 0 than release both buttons.
4. Press selection button 3. Service level 3 is reached. Display shows: 3_ _ _.
Low Level
BGM
Mic.-Kit
L
R
Line Out
L
R
Input Tape
L
R
Input CD
Amplifier F91
0039155
BGM Level
R
L
LR
Clipping
P10
Remote
P10
Remote
P4
1
2
4
1
2
4
Tone
off on
Treble
Bass
1
2
4
8
16
32
1
2
4
8
16
32
Volume
off on
R
L
Mode
Input
CD
Stereo
Tape
2-Kanal
R
L
pots to level
the BGM volume
BGM light emitting diode
(yellow), indicates whether
BGM is active
To Next Page
Loading...
