XEROX WIDE FORMAT COPY SYSTEM Job Accounting • 133
Job Accounting
Job Accounting
NOTE: The JOB ACCOUNTING feature is included in the WIDE
FORMAT COPY SYSTEM 8830, 8850, , 510 Series and 721P. It is an
optional feature on the WIDE FORMAT COPY SYSTEM 8825 and X2
TECH. If you obtain this feature, the System Administrator can enable it
at any time on the WIDE FORMAT COPY SYSTEM 8825 and X2 TECH
by sending a special feature key file to the Printer. Once the feature is
enabled, it remains enabled (even following upgrades to the system
software). Contact your XEROX sales representative for ordering
information.
Overview
JOB ACCOUNTING is a SYSTEM ADMINISTRATION menu option.
Access to it is restricted to the system administrator and requires the
entry of the system administration password.
The JOB ACCOUNTING option allows Scanner and Printer usage to be
recorded in user defined account numbers. Usage is expressed as the
area (not the length) of the media scanned or used.
Job Accounting for the Scanner is controlled through the Scanner
Control Panel. For the WIDE FORMAT COPY SYSTEM 8825, 8830,
8850, 510 Series, and 721P, Job Accounting for the Printer can be set
from either the Printer Control Panel or the Web-based Printer
Management Tool (PMT). For the WIDE FORMAT COPY SYSTEM
721P and X2 TECH, Job Accounting for the Printer can be set from the
Web PMT only.
The Web PMT consists of special Web pages located in the Controller.
They are accessible through either the Microsoft Internet Explorer or the
Netscape browsers. Version 4.0 or higher is required for proper results.
Other Web browsers are not supported and may or may not work
correctly.
Job Accounting can be set on the Scanner or Printer to one of three
modes. The modes are:
• ENABLED all jobs require a valid account number,
• OPTIONAL a valid account number is optional for any job
To Next Page
Loading...
Need help?
General