XEROX WIDE FORMAT COPY SYSTEM Scanning when using a Folder • 53
Scanning when using a Folder
Scanning when using a Folder
When using a Folder, the document must be inserted in the correct
orientaqtion in order to have the title block visible after the copy is folded.
Refer to the Finisher key information in the Special feature keys section
of this manual for additional information to set up the desired fold and
other Finisher options. Documents larger than 80 inches (2.1M) can only
be partially folded.
When using the Reduce/Enlarge feature and a Folder, you must orient
and insert the document title block in the same orientation as the
resulting enlargement or reduction copy size. In addition, the
recommended media should be used.
For example: the job requires that an A (A4) document be enlarged to a
C (A2) document. To have the title block be visible after folding, the A
(A4) document must be inserted as if it were a C (A2) document.
You may want to refer to "CUSTOM R/E PRESETS" in the "Main Menu,
COPY OPTIONS" section, and set up the
REDUCTION/ENLARGEMENT default to show the standard reduction
and enlargement. Set the reduction /enlargement to display A to C (A4
to A2) above the keys.
To ensure that the selected fold is made correctly, it is critical that the
document be centered on the Scanner Document Feed Tray when
scanning.
For additional folding and title block positioning information, refer to the
Folder Operator Manual or the Folding Supplement CD.
To Next Page
Loading...
Need help?
General