Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
requirements include safety agency examination, approval, and compliance with established
environmental standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation of your
printer.
OOppeerraattiioonnaall GGuuiiddeelliinneess
• When the printer is printing, do not remove any paper trays.
• When the printer is printing, do not open the doors.
• When the printer is printing, do not move it.
• Keep hands, hair, neckties, and so on, away from the printer exit and feed rollers.
• Covers, which require tools for removal, protect the hazard areas within the printer. Do not remove
the protective covers.
Hot Warning: The metallic surfaces in the Fuser area are hot. Use caution when you
remove paper jams from this area and avoid touching any metallic surfaces.
• Do not override any electrical or mechanical interlock devices.
• Do not attempt to remove paper that is jammed deeply inside the printer. Power off the printer
promptly, and then contact your local Xerox representative.
• To avoid a tip hazard, do not push or move the device when all paper trays are extended.
OOzzoonnee RReelleeaassee
This printer produces ozone during regular operation. The amount of ozone produced depends on
copy volume. Ozone is heavier than air and is not produced in amounts large enough to harm anyone.
Install the printer in a well-ventilated room.
For more information, contact your local Xerox representative, or go to www.xerox.com/environment_
europe.
Xerox
®
B1025 Multifunction Printer
User Guide
13
Safety
To Next Page
Loading...
Need help?
General
Weight and Dimensions
