Installation
16 DocuMate 765 Scanner User’s Guide
Step 3: Connect the Scanner
NOTE: Only use the power cord included with your scanner. Connecting
any other type of power cord may damage your scanner, and will void its
warranty.
1. Plug the power supply into the power port on the scanner and to a
wall outlet.
2. Remove any protective tape from the USB cable.
3. Plug the USB cable into the USB port on the scanner then into a USB
2.0 port on the computer.
The DocuMate 765 scanner connects to any available USB port.
Check your computer’s manual for USB port locations.
4. Turn on the power switch, located on the front of the scanner.
The status light comes on and flashes indicating that the scanner is
receiving power.
Your computer recognizes that a scanner has been plugged into the
USB port and automatically loads the appropriate software to run the
scanner.
If your computer is running Windows XP or Windows Vista, you will
see a Found New Hardware message similar to the following:
To Next Page
Loading...
Need help?
General