Scanning from ISIS
90 DocuMate 765 Scanner User’s Guide
Imprinter Options
The Imprinter tab is where you set the options for the pre-scan imprinter.
The imprinter pre-prints data on a page just before the paper is pulled
through the scanner, the printed data is then captured in the final image.
The the options for the imprinter are only available if you have an
imprinter unit installed in your scanner. The imprinter unit is an optional
accessory that you can purchase from our website, in the Parts &
Accessories page for your scanner, at www.xeroxscanners.com.
1. Click on Enable to turn on the imprinter function.
2. Select the options for the imprinter.
Bold Font—select this option to print everything in a bold font.
Imprinter String—input the characters you want printed on each
page.
The following table shows the available alphanumeric characters and
symbols that can be printed. A maximum of 72 characters can be
printed.
Printing Offset—input an offset number where printing should occur.
A 10 mm offset is always added to this value.
Unit: 2.38 mm per increment (printing orientation: 900, 270°)
1: 12.38 mm
2: 14.76 mm
Unit: 3.44 mm per increment (printing orientation: 00, 180°)
1: 13.33 mm
2: 16.88 mm
Orientation—click the down arrow and choose an orientation for the
imprint to appear on the page.
Start Number—type in the default value of the counter specified by
the imprinter string.
10 mm
10 mmPrinting area
Paper feed
direction
Orientation
To Next Page
Loading...
Need help?
General