Xerox Phaser 7400

Printing on Both Sides of the Paper
Phaser® 7400 Color Printer
3-29
Printing on Both Sides of the Paper
This section includes:
■ Automatic 2-Sided Printing Guidelines on page 3-29
■ Binding Edge Options on page 3-30
■ Selecting 2-Sided Printing on page 3-30
Note: For information about manual two-sided printing, go to the Knowledge Base at
www.xerox.com/office/7400support
.
Automatic 2-Sided Printing Guidelines
Automatic two-sided printing is available from all trays. Before printing a two-sided
document, verify the following requirements:
■ You must have a Phaser 7400DN, Phaser 7400DT, Phaser 7400DX, or Phaser 7400DXF
printer.
■ The paper you are using must be within the following ranges:
■ Weight: 75–188 g/m
2
(20–50 lb. Bond)
■ Length: 148–456 mm (5.83–17.95 in.)
The following paper and media cannot be used for 2-sided printing:
■ Transparencies
■ Envelopes
■ Labels
■ Card stock
■ Glossy paper
■ Media that is heavier than 188 g/m
2
(28 lb. Bond)
See also:
Options on page 1-5
Supported Paper and Media on page 3-3