Printing on Specialty Media
Phaser® 7400 Color Printer
3-32
Printing on Specialty Media
This section includes:
■ Printing Transparencies on page 3-32
■ Printing Envelopes on page 3-37
■ Printing Labels on page 3-40
■ Printing Glossy Paper on page 42
■ Printing Custom Size Paper on page 3-45
For information about printing on other types of specialty media, see the
Advanced Features Guide at www.xerox.com/office/7400support
Printing Transparencies
Transparencies can be printed from Tray 1 (MPT) and Tray 2. They should be printed on one
side only.
For best results, use only transparencies that are recommended for your printer. For more
information, see the Recommended Media List at www.xerox.com/office/7400support
To order paper, transparencies, or other specialty media, contact your local reseller or go to
www.xerox.com/office/supplies
.
Caution: Damage caused by using unsupported paper, transparencies, and other specialty
media is not covered by the Xerox warranty, service agreement, or Total Satisfaction
Guarantee. The Total Satisfaction Guarantee is available in the United States and Canada.
Coverage may vary outside these areas; please contact your local representative for details.
Guidelines
■ Remove all paper before loading transparencies in the tray.
■ Do not load more than 50 transparencies in Tray 1 (MPT). Do not load more than
200 transparencies in Tray 2. Overloading the tray may cause the printer to jam.
■ Handle transparencies by the edges using both hands to avoid fingerprints and creases,
which can cause poor print quality.
■ After loading the transparencies in the tray, use the control panel to change the paper type
to Phaser 35-Series Transparency.